Pesh115
New Member
I am in the middle of a series (three) of toilet upgrades in a relative new home (built in 2018) which has three bathrooms.
The first two bathrooms had 12" from wall to rough-in center and the standard Toto 12" adapter worked great. I just removed the third and final toilet to find the center of rough-in is at about 11-1/4" from the base board. When I put the 12"adapter, as far forward as possible, I end up with 1/4-to-3/8" from wall. The adapter is sitting flush on the ground and clearing the baseboard (height-wise). My water supply line is to the left of the toilet at about 8" left of center of rough-in.
Attached are pictures with the supplied 12" rough-in adapter.
Can I go ahead and use the 12" adapter with a super tight fit?
Or should I get the 10" adapter and have more space between back of toilet and wall?
The first two bathrooms had 12" from wall to rough-in center and the standard Toto 12" adapter worked great. I just removed the third and final toilet to find the center of rough-in is at about 11-1/4" from the base board. When I put the 12"adapter, as far forward as possible, I end up with 1/4-to-3/8" from wall. The adapter is sitting flush on the ground and clearing the baseboard (height-wise). My water supply line is to the left of the toilet at about 8" left of center of rough-in.
Attached are pictures with the supplied 12" rough-in adapter.
Can I go ahead and use the 12" adapter with a super tight fit?
Or should I get the 10" adapter and have more space between back of toilet and wall?