Latest activity
-
Darkflux replied to the thread Capping Iron Pipe.interesting...i might try that. though those 1-1/4 inch SharkBote caps are pretty pricey
-
Terry replied to the thread Vent Stack questions.Plumbing code expects to see the same area going through the roof, as out to the street on the sewer. A three bath home can be done... -
Terry replied to the thread Replacing kitchen faucet.An allen wrench to remove the Costco faucet from the top...
-
My older model, since replaced, had a small bolt connecting the tube to the brine tank wall, a few inches below the yellow cap. Check... -
Ryanmw replied to the thread Whirlpool Softener Brine Well is Loose?.It is connected to the wall at the top.. just wasn't sure if it is supposed to be secured at the bottom or just held in place by the salt.
-
(Residence in Florida, and before I call the local Bldg Inspection office and get the usual run around, I wanted to get some practical... -
Fitter30 replied to the thread Condensate neutralizer requirements.Its not how the piping will fail its when. Is their a townhouse association who pays for it? Since the pipe will fail from the inside out . -
Bingow replied to the thread Whirlpool Softener Brine Well is Loose?.My older model, since replaced, had a small bolt connecting the tube to the brine tank wall, a few inches below the yellow cap. Check... -
James Henry replied to the thread Vent locations on new build.Your struggling. https://www.ipscorp.com/pdf/studor/Studor_Technical_Manual.pdf -
Ryanmw posted the thread Whirlpool Softener Brine Well is Loose? in Water Softener Forum, Questions and Answers.I installed a new Whirlpool WHES40 in January of this year and last month the pressure vessel broke spraying water out into the garage...
-
breplum replied to the thread Replacing kitchen faucet.I think i see a nut up there. The original faucet would have come with a special tubular socket wrench to match that nut. Without the... -
breplum replied to the thread Shutoff Valve for CPVC to PEX.Push fit from major name brands are fine, incl Sharkbite. When installed properly, including support they should perform 100%.
-
wwhitney replied to the thread Vent locations on new build.Yes, that's fine, with the provisos: Everything listed above as 4" could be 3". 2" x 4" 90 sweep is usually called a 4x4x2 combo... -
John Gayewski replied to the thread Capping Iron Pipe.If you can sand the surface smooth a pvc sharkbite should fit. -
Wayner123 replied to the thread Vent locations on new build.I took out the utility sink for now. If I need to add it back, I will simply take it out the side wall and into the landscaping. I... -
