Zane Bridgers
Member
I've been binge researching submersible pumps here. A shout out to valveman and the community for the incredible depth of information. What I gather is:
- No one makes good pumps anymore (a crying shame)
- Install a CSV to extend the life of the low quality pumps
- Grundfos is still arguably the best, with SS impellers, even if thin
We just forked out almost $20k for our well and are pretty flat out, so I'm trying to figure out an economical pump from an at least somewhat reputable company. The static water level is 360', well is 455' and capable of 18gpm and will be shared by two small homes. I think 30/50psi would be adequate for our single story. I can get a:
- Goulds 10CS15422C 10GPM 1.5HP for $480 new, under warranty - but I've heard folks don't trust the CS line - is it the pump or the CentriPro motor, or both that are a cause for concern?
- Grundfos 96160144 10GPM 1.5HP for $811
- A Betta-flow and Hydro-flo pump, but I could not find any residential models/curves online
- A franklin motor and separate pump end - or is franklin no better than the rest these days...
I also wonder if I should really be looking in the 2HP range since the flow on these isn't fantastic at this depth/pressure, but it will just be our 1 bed/1 bath for the next couple years until our neighbor builds so trying to avoid too much additional expense.
As for CSV's, is the PK1A PSIDE-KICK kit a good option?
Many thanks! I look forward to learning more
- No one makes good pumps anymore (a crying shame)
- Install a CSV to extend the life of the low quality pumps
- Grundfos is still arguably the best, with SS impellers, even if thin
We just forked out almost $20k for our well and are pretty flat out, so I'm trying to figure out an economical pump from an at least somewhat reputable company. The static water level is 360', well is 455' and capable of 18gpm and will be shared by two small homes. I think 30/50psi would be adequate for our single story. I can get a:
- Goulds 10CS15422C 10GPM 1.5HP for $480 new, under warranty - but I've heard folks don't trust the CS line - is it the pump or the CentriPro motor, or both that are a cause for concern?
- Grundfos 96160144 10GPM 1.5HP for $811
- A Betta-flow and Hydro-flo pump, but I could not find any residential models/curves online
- A franklin motor and separate pump end - or is franklin no better than the rest these days...
I also wonder if I should really be looking in the 2HP range since the flow on these isn't fantastic at this depth/pressure, but it will just be our 1 bed/1 bath for the next couple years until our neighbor builds so trying to avoid too much additional expense.
As for CSV's, is the PK1A PSIDE-KICK kit a good option?
Many thanks! I look forward to learning more
Last edited: