TRH
New Member
After getting some good information from this site, I removed the cartridge from my Moen shower valve and purchased a new 1225 cartridge. I tried to install it, but it would not go in the last 1/2 inch. In removing it I destroyed it. I now have a 1220 that is also short of all the way in by about 1/2 inch.
Before I put the 1220 in I checked the opening for obstructions, measured the depth of the opening, lubed the cartridge, and followed the instructions to the best of my ability. Any ideas about why it will not go all the way in or actions I should take?
Thanks in advance.
Before I put the 1220 in I checked the opening for obstructions, measured the depth of the opening, lubed the cartridge, and followed the instructions to the best of my ability. Any ideas about why it will not go all the way in or actions I should take?
Thanks in advance.