Thomas K
Member
Hi, guys! I may not be in the right forum here, but hope I'm close. I finally decided that best way to vent stacked dryer was straight up through the roof, capping it with a Dryer Jack Model 477 outlet. My question: Is there any way to seal the rotating collars of this Whirlpool 4396006rw close-quarters 90 degree dryer fitting so they don't leak hot air after installation? I thought about using the Dundas Jafine telescoping vent, but decided not to because it would be difficult to get a vacuum cleaner up into the slim portion of it to clean it, and it has a lot of edges in it that could catch lint.
I have a few days off coming up and would like to get something done for a change.
Thanks for any replies!
I have a few days off coming up and would like to get something done for a change.
Thanks for any replies!
Last edited by a moderator: