leak

  1. JD3263

    Water Leaking from AC Condensate Pan

    Rheem Model: RCHL-48A1G MFG Date: 05/2009 Hello, I have a lot of water dripping onto the AC filter and from what appears to be the condensate tray. The AC blows cold air and seems to be functioning normally; it's just the leaking that's a problem. I used a shop vac on the drain pipes from...
  2. Pakaderm

    Can you identify this plumbing 'manifold' coming up from the foundation? SoCal?

    Hello, new to the forums and need help with this. I recently opened the area under my stairs and found this 'manifold' coming out of the concrete foundation. Does anyone know why there are 3 hot and 4 cold lines coming out of the foundation, and why they loop back on themselves? The hot/cold at...
  3. Mcgee22

    How for fix a small leak in a vertical connection of half-inch copper

    I discovered a tiny leak in a vertical connection above a shower posi-temp valve. Can I heat and add more solder to that section, or does the whole assembling from the posi up to the shower head need to be reconstructed? This was installed along with converting all steel pipe in the house to...
  4. TheOverThinker

    Repacking an inverted oakum / cast iron 4" joint on a sewer stack?

    How, and who, can still repair old oakum joints that are inverted. Situation is a 4" CI waste stack comes down from the roof above the top floor toilet in an condo. Just above the toilet, it branches downward for the tub. The walls and everything are all finished. mostly with tile. The three...
  5. StefanieG

    Water still running even though valve is closed

    We had a slab leak repaired a few months back. It is leaking again. The leak is from a hot water line in the kitchen. We found our floor became hot again. The floor was reopened to verify the leak. We shut off the water at the hot water tank (valve) and allowed the lines to drain. Its been...
  6. Mjkarabela

    Rebuilt Pump - Still leaking around gasket

    Hey Fellas, I got this old Duro K-255 piston pump. Last night, wasn't holding prime over night, so took it home and rebuilt it. However, there is still like 5 drips per 20 seconds coming out around this gasket, not under pressure. The mating surfaces are a bit pitted, but I was hoping the...
  7. Shinysquid

    Need to replace a valve on a short PEX pipe- any hope to DIY?

    Hello - I found an issue with my water intake valve where there is a drip from the valve when the water is on. It drips from the right most side of the valve where there is a horizontal line/cutout. The valve seems to be one solid piece with no removable parts so I think my only fix for this is...
  8. RC50

    Water in yard when pump runs

    I have a well system, metal encased well. Everything works fine, but about 25ft from the well I'm getting standing water on the grass. I'm noticing this when I do laundry when it's drawing more water I'm assuming or when it's backflushing, I have a neutralizer tank. Just from internet searching...
  9. Paiksl

    Are these water leaks from thermal imaging?

    Hey All!! So recently getting ready to buy a new house. Looked through it and saw these images through thermal readings Wondering if these are indicative of a water leak somewhere. Thanks!
  10. PierreYC

    Toto Aquia I CT414M tank to bowl leak / replace TS810DV2 rubber washer ?

    Hello I’m currently trying to reinstall a Toto CT414 / Aquia I toilet, but can’t figure out how to fix the leak coming from the tank to bowl nuts connection. I have already checked the supply valve and flush 3" : they don’t leak. After two unsuccessful installations, I placed the toilet...
  11. hhussey

    Dishwasher plumbing - high loop causing occasional leak

    Hello! I have two questions. A.) I had a leak from my dishwasher years ago, but it seemed like a one-time thing and my husband at the time didn't know why it leaked. But this morning I heard a backup sound from the plumbing under my sink and water was in the cabinet under my sink and on the...
  12. Narshe9999

    Leaking Grohe Grohtherm 1000 Temperature Control. New shower could be installed within a month. How should I fix this without throwing away $300?

    Hello! This installation is about 20 years old now, and this is the first problem I've had. It leaks whether the shower is running or off. It leaks whether the temperature control knob is turned hot, cold or in between. It has been leaking for 2 weeks. And the leaking is getting a lot worse...
  13. marshall62

    Ventilation stack leak

    We have heavily used shower in an upstairs bathroom (with exhaust fan) that drains into a pipe that runs up/down an outside wall into the attic where it then turns and runs horizontally in toward the center of the building where it joins a larger diameter stack pipe. Its very cold in our attic...
  14. BabaCharles

    Navien NPE-240A condensate drain leak

    I bought a home a few months ago that had a Navien tankless water heater installed in 2019. Yesterday I noticed lots of water coming out of the condensate drain. The floor beneath the unit was a little wet too but whatever caused that bit of moisture has seemed to have stopped. But the water...
  15. TheOverThinker

    Keeney Manufacturing Company 1/4 turn defective leaking ball valve

    I've got a 1/4 turn ball valve that's leaking. Looking at it, the shaft appears to be plastic and its dripping pretty good. Going to the local ACE and checking Lowes online, they sell what looks like the same valve. Is Keeney a generally good brand, or should I hold out for something higher...
  16. Peterac78

    Plumbing/water heater- spots recently on ceiling downstairs, 2 story house. Condensation??? New wate

    Plumbing/water heater- spots recently on ceiling downstairs, 2 story house. Condensation??? New water heater. Live in home now for 20 years but could happen anywhere. Got a new water heater in September on 2nd floor in a tiny closet. In that closet is a metal aluminum vent and also a white...
  17. BostonGuido

    Seepage around PCV coupler through concrete wall

    I have a rain water cistern, and the inlet and overflow pipes (3" PVC) penetrate the wall at the top of the 7' deep cistern. The pipe penetration was done by placing an ordinary 3" nominal PVC coupler in the poured concrete wall when it was poured. The PVC pipes were then passed through the...
  18. MoonmanH3

    Newly Installed Slip fit shower drain leaks

    Hello all, We are installing an acrylic shower base and I wanted to test fit the drain. I am using this drain: https://www.homedepot.ca/product/pro-connect-abs-shower-drain-white-grid-slipfit/1000117477 It seems like a fairly typical design for 2” drains. There are several versions of this...
  19. losten

    Bathroom sink leaking from water supply connection to faucet

    Hello, all. I recently discovered that my bathroom sink was leaking where the cold water supply line connects to the underside of the faucet. I initially tried tightening the connection but that didn’t help. I replaced the water supply line but I am still having the same issue with it leaking at...
  20. Mark415

    Galvanized Since Waste Pipe Replacement/Repair

    (edit--Galvanized SINK waste pipe...) I am a former flooring contractor/carpenter, so I know my way around a home. Two days ago, I was away for 2 days, and the galvanized waste pipe under the kitchen sink started to leak. My wife called multiple plumbers, and finally got a guy to come out from a...
Top
Hey, wait a minute.

This is awkward, but...

It looks like you're using an ad blocker. We get it, but (1) terrylove.com can't live without ads, and (2) ad blockers can cause issues with videos and comments. If you'd like to support the site, please allow ads.

If any particular ad is your REASON for blocking ads, please let us know. We might be able to do something about it. Thanks.
I've Disabled AdBlock    No Thanks