Jag_Man653
Member
The instructions for installation of my new Watts residential RO system give instructions for pre-filling and sanitizating the storage tank. It says to connect the tank to the "feed water line." If I understand correctly, this will put mains pressure on the tank, whereas in the normal hookup the pressure seen by the tank is after going through 4 stages of filtration.
Will the tank take mains pressure, perhaps 50-60 psi?
Is this procedure recommended and necessary?
Just want to be sure I don't ruin something.
TIA
Ed
Will the tank take mains pressure, perhaps 50-60 psi?
Is this procedure recommended and necessary?
Just want to be sure I don't ruin something.
TIA
Ed