Pman6
Member
I thought I would be able to solder, but all I created was a leaky valve.
So I installed this compression valve on my water heater instead.
Used a whole lotta strength to tighten these nuts.
Can I rest assured there's a very super unlikely chance this valve will blow itself off?
I sanded both copper pipes going into this valve.
There's a tiny leak at the nut on the right side. Can I super tighten the nut without damaging the pipe coming out of the wall?
So I installed this compression valve on my water heater instead.
Used a whole lotta strength to tighten these nuts.
Can I rest assured there's a very super unlikely chance this valve will blow itself off?
I sanded both copper pipes going into this valve.
There's a tiny leak at the nut on the right side. Can I super tighten the nut without damaging the pipe coming out of the wall?