kat-diy
New Member
- Messages
- 23
- Reaction score
- 0
- Points
- 0
Hi all you helpful people! Got another question for you.
I went to Lowe's today to get a spout nipple only to find out that the special size I need can't be cut by them or other such stores. So I came here to read and discovered that what I was trying to do wasn't right anyway. (We were going to use galvanized pipe and from what I've read here, that's not right, correct?)
I've read that we can fabricate one but it sounds as though with our set up that copper would not be sturdy enough. We need a 6 5/8 inch pipe that is threaded on both ends, to screw into the wall and then the spout onto that. So, if we don't want galvanized and copper is too weak with such a set up, what do we do here? Thanks for any help!
I went to Lowe's today to get a spout nipple only to find out that the special size I need can't be cut by them or other such stores. So I came here to read and discovered that what I was trying to do wasn't right anyway. (We were going to use galvanized pipe and from what I've read here, that's not right, correct?)
I've read that we can fabricate one but it sounds as though with our set up that copper would not be sturdy enough. We need a 6 5/8 inch pipe that is threaded on both ends, to screw into the wall and then the spout onto that. So, if we don't want galvanized and copper is too weak with such a set up, what do we do here? Thanks for any help!