Shower pan question

Discussion in 'Shower & Bathtub Forum & Blog' started by jblackhwt, Jun 18, 2006.

  1. jblackhwt

    jblackhwt New Member

    Jun 18, 2006
    Hey guys,

    Couple questions.
    First, I just ripped out my garden tub, and going to replace it with a shower pan. The drain from the tub was 1.5" pvc. Now I need to make that a 2" all the way to the stack correct? Why?

    Do I need to vent the drain, as it is only 4-5' to the stack. I have to cut out the over flow so the pan fits.

    Next, the area in which the pan needs. The old tub drain and new pan do not match up of course. I need to bring out the old tub drain 5", but where it needs to go there is a joist in the way. I don't want to furr out the wall b/c I need all the space that I can ( crappers close)

    Any suggestions or ideas.

    Thank you for your help and time,

  2. jimbo

    jimbo Plumber

    Aug 31, 2004
    San Diego, CA
    Code requires 2" for showers. Some would question the logic,because millions of people are taking showers in tubs with the 1½" drain! Especially now that showers are all 2.5 GPM low flow.

    The rationale that I can put to this is that a shower pan has a low curb, and thus very little tolerance for any occasional backup, whereas we have probably all taken a shower in a slow draining tub with water over the ankles, but otherwise no consequences.
  3. Sponsor

    Sponsor Paid Advertisement

Similar Threads: Shower question
Forum Title Date
Shower & Bathtub Forum & Blog Basement bath & shower question Friday at 4:28 PM
Shower & Bathtub Forum & Blog 1st shower valve stem repair -- access question Thursday at 7:18 AM
Shower & Bathtub Forum & Blog Questionable Shower Drain in New House Jan 14, 2018
Shower & Bathtub Forum & Blog Shower pan liner question Jan 9, 2018
Shower & Bathtub Forum & Blog Question about Delta Rough in valves - shower only vs shower and bath Dec 21, 2017

Share This Page