Search results

Hi, I have a Toto Ultramax II toilet with the CEFIONTECT finish. I've been gone for 2 months and now have a water ring in the bowl. I'm looking for suggestions how to remov the ring without being harsh on the bowl surface. Thank you

Hi, I am replacing a faucet in a RV. I can't get it too stop leaking. The first picture with the male brass fitting is in the RV and at the joint that's leaking. The second picture shows two fittings. The one on the left with the hose that was orignally there. The brass fitting on the...

Hi, I'm installing an Oatey Set Rite toilet flange extender. A couple of questions. 1. A couple of the screw holes where the new flange (yellow) will sit directly over where screws are located for the existing lower flange. Those should be removed from the existing lower flange? Correct...

Hi, I am replacing my bathroom fan. Due to the location, I can not just put the new one in the same location for 2 reasons; (1) The grill for the replacment fan will entend and hit the wall on the left. (2). The HVAC ductwork is right above. So I need to place the new fan box to the right...

Hi, We are buying a new double sink bathroom vanity. The hardware (Moen) we bought for it is a single control faucet that requires only one hole in the sink. They will drill a double hole if we want. The hardware (Moen) does come with a plate to cover the double hole. Should we get the...

Hi, I have a Toto Ultra max II one piece on order. The flange is in the correct location per the spec. sheet (12" CL from finished wall). But my water supply is on the floor vs. the wall. I think it will be fine, but wanted to check with others. It appears to be outside the toilet...

Hi, I'm doing a bathroom remodel and plan to put in a bathroom niche in a 3' x5' alcove type area. Ideally I would like to out the niche on the 5' wall, but that is an outside wall and the insulation would have to be removed. Is it ok to do this? Would there be freezing or condensation...

Hi, This was my first solder job (practiced on many pieces). There are no leaks...is good (no leaks) "good"? Its been suggested (wifey), that I should get someone to "check it out" before enclosing the walls. Thank you.

Hi, The main water gate valve to my house broke and the plumber wants to use ProPress vs solder. Would these be ok for this application? Is the reliability good? Thank you

Hi, First, thank you to everyone who times the time to answer questions. I'm a first time bath room remodeler. I have a new Kohler tub that has four feet vs "non feet" bottom. Elmbrook, K-23217-RA The tub is level left to right, but front to back is out a bit. What is used to level the feet...

Hi, This is my first remodel. I plan to place shutoff valves on the copper piping near the bottom wood 2 x 4 plate. A friend who is going to help me with the soldering, says I should replace all the other copper piping (copper spout and valve body). He says it jus something he always...

Hi, What are the techniques to get a tub into the alcove during a remodel. The alcove is 60", but with the drywall, (ahead of the alcove), the width is only 59" Thank you