Search results

  1. Steve Soldo

    Tankless Venting Question

    Replacing an Bosch Aquastar with a Navien condensing unit, indoors. Previous system had a 5 inch exhaust galvanized ducting. I can run the 2 inch exhaust line PVC through the existing 5 inch duct. But I am not sure how to secure the PVC as it travels through there, especially at the roof...
  2. Steve Soldo

    New Tankless Venting Question

    Back house has an indoor located Bosch Aquastar that died. Never really worked that well anyway. So I need to replace it. Need a smaller unit, as there are only 2 sinks and one shower. The water and gas hookups are easy. This will need to be wired, and that is not difficult either. There...
  3. Steve Soldo

    New Fleck 5600 SXT not counting gallons properly: Defective unit, or not programmed properly?

    Will try to make long story short: • Purchased a Fleck 5600 SXT in 2018 from a company in Arizona that is now defunct. Some of you may be familiar with the company. • Kept it in storage for 3 years as my Culligan was still working • When the Culligan finally died, I installed this Fleck a...
  4. Steve Soldo

    Replacement Culligan Circuit Board

    Have a Culligan Silver Series softener for 20 years. . As expected, I have replaced parts here and there. Problem I have now is that the Circuit Board has failed, Part Number is 01-0130-94 Question: Does anyone know if this is available anymore ? If not, is there a replacement. Note: I...
  5. Steve Soldo

    Confusing settings for Culligan unit

    Have a Culligan unit that has been well maintained. Resin and seals recently changed, however, the circuit board, for some reason, did a hard reset and I do not remember the "optimal" settings and had to reprogram it. The unit does regenerate but the water remains somewhat hard, confirmed by...
  6. Steve Soldo

    I am done with Culligan

    18 year old Culligan Silver Series. Long story short: Stopped producing soft water about 4 mos ago I replaced the resin with an appropriate product and amount Water was soft for about a week, then hard again (by feel and also test strips) The unit still consumed salt despite hard water Used...
  7. Steve Soldo

    Culligan Only Regenerates Manually

    Culligan Gold Series installed in my home 1999, 9 inch Over the years have changed the seals, and usually this addresses problems. Last 6 months not using salt. Doing the diagnostics on the circuit board, is not regenerating. There is a feature that shows how many times it has regenerated...
Top
Hey, wait a minute.

This is awkward, but...

It looks like you're using an ad blocker. We get it, but (1) terrylove.com can't live without ads, and (2) ad blockers can cause issues with videos and comments. If you'd like to support the site, please allow ads.

If any particular ad is your REASON for blocking ads, please let us know. We might be able to do something about it. Thanks.
I've Disabled AdBlock    No Thanks