Ballvalve
General Engineering Contractor
I have a few 1/2 hp 13 stage older - new Graingers submersible pumps. Probably Myers built, cast heads. The chart says 300' of head max with 20 psi output, about 2.3 GPM , by recollection. Having a few 1 and 1.5 HP Franklin motors laying about, what might I expect swapping them for the 1/2 hp motor?
The booklet from Graingers shows a 14 stage 1 hp maxing out around 375' . I am filling a water tank high up the hill, so I am not pressurizing anything. Do you full time pump masters stock pump heads and then add a motor to suit the site conditions?
The booklet from Graingers shows a 14 stage 1 hp maxing out around 375' . I am filling a water tank high up the hill, so I am not pressurizing anything. Do you full time pump masters stock pump heads and then add a motor to suit the site conditions?