ballvalve
Last Activity:
Sep 13, 2017
Joined:
Dec 28, 2009
Messages:
3,465
Likes Received:
23
Trophy Points:
38

Followers 3

  1. jamesnoirer
  2. PumpMd
  3. Letsrunum
Location:
northfork, california
Occupation:
"retired" and still building and troubleshooting

Share This Page

ballvalve

General Engineering Contractor, from northfork, california

ballvalve was last seen:
Sep 13, 2017
    1. kathy kam
      kathy kam
      Hello. I am female and pipe-challenged. I have a hairline crack around the ball of the brass on-off stem of the drain valve on my 2 year-old AO Smith electric water heater. It is not dripping but wet to the touch with mild corrosion. Rather than go through the costly labor of valve replacement, could the corrosion be sanded away and epoxy carefully pushed into the crack? Thanks
      Sep 12, 2017
    2. ButchNH
      ButchNH
      Hey,

      New to the forum, reading up on sewage ejectors and really appreciated some of your posts I read! It's nice to see someone post intelligent replies in reponse to some of the "experts" who think anyone else's ideas are wrong.
      May 8, 2011
    3. ilya
      ilya
      I actually kind of enjoy working on knob and tube-it was a pretty good system.
      Oct 13, 2010
  • Loading...
  • Loading...

  • About

    Location:
    northfork, california
    Occupation:
    "retired" and still building and troubleshooting
    retired general, electrical, plumbing contractor

    moving the earth and subdividing land

    Interact

    Content: