Spill switch installation for Honeywell WT8840 gas valve

Users who are viewing this thread

Frozen23

New Member
Messages
15
Reaction score
0
Points
1
Location
12590
My plumbing inspector mentioned I need to install a spill switch over my AO Smith natural gas tank water heater exhaust vent. The water heater has WT8840 gas valve. I failed on searching info how to marry SSK-3 switch and WT8840 gas valve. Is there a wiring diagram? Because the one that comes with SSK-3 is useless proposing to use a junction block. I haven't found the thermocouple on the valve. Just ignition wire and 2 thermopile wires

wt8840b.jpg
 
Last edited:

JHBergeron

New Member
Messages
1
Reaction score
0
Points
1
Location
Poughkeepsie
My plumbing inspector mentioned I need to install a spill switch over my AO Smith natural gas tank water heater exhaust vent. The water heater has WT8840 gas valve. I failed on searching info how to marry SSK-3 switch and WT8840 gas valve. Is there a wiring diagram? Because the one that comes with SSK-3 is useless proposing to use a junction block. I haven't found the thermocouple on the valve. Just ignition wire and 2 thermopile wires
Did you ever get an answer to your inquiry? I need the same instruction
 
Top