IPC Table 706.3 - Fittings for Change in Direction

Discussion in 'IPC Plumbing Code Questions' started by PHXCADPlumber, Sep 11, 2014.

  1. PHXCADPlumber

    PHXCADPlumber New Member

    Joined:
    Sep 11, 2014
    Hello,

    I have a question in interpreting Table 706.3. If I understand the rule correctly:

    1.) Horizontal to Horizontal can only be made using a long sweep, back to back 1/8 bends, or wye-1/8 bend (combination fitting/Wye-Tee).

    Am I correct in my reading, or am I all wet on this? A short sweep would not be allowed. Talking Cast Iron specifically. And not talking about a 1/4 bend; I know that would be a violation.
     
    Last edited: Sep 11, 2014
  2. hj

    hj Master Plumber

    Joined:
    Aug 31, 2004
    Occupation:
    Plumber
    Location:
    Cave Creek, Arizona
    In cast iron, a short sweep IS a 1/4 bend.
     
  3. Sponsor

    Sponsor Paid Advertisement

     
Similar Threads: Table 7063
Forum Title Date
IPC Plumbing Code Questions Minimum Separation Requirements between water service line and non-potable pipes Oct 25, 2012

Share This Page