jspx
New Member
I'm re-doing a very poorly done bathroom and all of the plumbing is a complete rip out (zero slope, sani-tees on their back to move waste etc) but all of the piping including the 3" heading out of the room was wrapped in silver foil foam insulation, the type for heating ducts. It's left foam chunks and adhesive residue all on the pipe. I can scrape the foam but the glue isn't coming off and it doesn't look anywhere clean enough to cement to. It also extends under the floor out of the room for several feet so there's nowhere to cut it back to either. Are there any products that I can use to remove the residue (wd-40, mineral spirits, goo gone, ???) that won't damage the pipe or interfere with the solvent cement later?
Thanks!
Thanks!