Yes. Level is not high. Your softner or KL filter would take that out.Manganese, total - 0.007 mg/L - this is OK, right?
Not high. Note the MCL**=250 for sulfate for example. 250 is where they would draw the line between high and moderate.Are these two high?
Sulfur, total, by ICP - 33.1 mg/L
Sulfate - 90 mg/L
Should it be added to the brine well or to the salt in the tank?Simply add a few ounces of household bleach to the brine tank.
I'm not sure I understood it. Can you please explain it.If it is be sure to acid clean it first.
The salt is in the brine well/tank. So same place.Should it be added to the brine well or to the salt in the tank?
Is there a way to tell if it's needed? The softener is new and according to water test, it does a good job of softening.If your resin is iron fouled you need to acid clean it before sanitizing.
You would have seen that in the drain line water about 15 or 20 minutes into the BD phase.Next I mixed about 3 ounces of bleach with 1 gallon of water, poured it into the WS brine well and started manual regeneration. But I did not smell any chlorine during the regeneration and test strips did not show any (but these strips are not sensitive and show only 10-200 ppm)
Yes.By BD do you mean the brining phase?
Chlorine should never be mixed with any type of acid as that will produce toxic chlorine gas which is a lung and eye irritant at best, and fatal at worst.So I'm not sure whether I put too little bleach or salt with iron remover neutralized chlorine.
This is awkward, but...
It looks like you're using an ad blocker. We get it, but (1) terrylove.com can't live without ads, and (2) ad blockers can cause issues with videos and comments. If you'd like to support the site, please allow ads.
If any particular ad is your REASON for blocking ads, please let us know. We might be able to do something about it. Thanks.