Search results

I'm sure someone here can help me ... I'm looking for a brass 3/4 inch quick disconnect valve for my propane line to my generator. The type that you slide the outer sleeve back : plug in the male part : and slide the outer sleeve of the female part back: locking it together leak free. Any...

- I have a basement bathroom with 2 sinks a toilet and a shower. - The home has 2 septic systems so the basement setup has a dedicated septic system. - When my sinks run the toilet bubbles and burps. If you were to flush it while it were bubbling the water would not go down and the shower...

Hi all. what is the best pressure to charge a RO holding tank too?

Can I use a faucet hose, 30" steel braided over rubber, to tie in my toe kick heater? Or is there some special type of hose or this ?

I'm ready to install a toe kick heater. I believe I have all the parts I need I just have one last question. At the entry point of the loop I have a "dual directional tee" (sorry for not knowing the real name). My question is can I use a regular tee on the output side or should I use another...

No need to ask my question ... I just discovered I installed my mono flow T incorrectly ...

To everyone that helped out out with my bathroom buildout... Thanks!! We're approved (with a nice compliment from the inspector on the neatness of the work) and everything is working perfectly!!! I could have NEVER done it without the concise and patient assistance from the professionals on...

Is there one that exsists? My shower base is PVC equiped but my waste lines are ABS and I dont have room for a fernco...

Please bear in mind that the vent tube will be tied into the vent for the shower going through the roof.

Hi all, I'm ready to put down my shower base which is a one piece molded presloped tile ready deal. The manufacturer recommends a latex modified thin set as a base. I also understand that I'd want to use a latex modified under my durock for the tile floor. I just picked up a bag of thin set...

Does anyone know where I can order plastic to copper no-hub couplers? I've been to 5 big box depots and some of the smaller guys and nothing! I need the ones that allow for the differant outside diameter between copper and plastic pipe.

So I have a tub/shower on the main floor of a ranch. It's 40 years old and during a remodel I've opened the ceiling below it (finished basement) The tub doesn't have a vent. Just the standard drain, trap etc. It's about 8 to 10 feet from the main drain out of the house. So how does this...

So, Help me understand the differance between a Pex Manifold thats open on both ends and the closed ended types. I'm not certain I understand the supply and return components of the pex manifold. Can anyone shed some light?

Will this work or will the tub not drain properly? The main waste pipe is 3" and vent will be a 2 1/2". The vent would be ~6 feet from the tub drain. I'm concerned about the position of the vent... I saw one plumbed like this, everytime the tub was drained, it backed up into the shower. Terry

I'm installing new platform tub and have discovered there is a floor joist DEAD CENTER under the tub long ways. What can be done now about the drain assembly? I can't imagine I'm the only person this has ever happened too. So, can anyone help with suggestions?:(

Is there a prefered material for waste lines and vents? I was told at the supply house that ABS is a better material for waste lines than pvc. If it is great, but would that also suggest that the vent should or could be abs as well? What do folks think?

I'm installing a new bathroom where there was none before in my house. My questions is, Is there a "correct" spot to install my vent stacks? For example, Should the toilet vent be upstream or downstream from the toilet? And if there is a toilet and a sink on the same waste line will a...