Jeremy Saddle
New Member
I sure could use some help at this point.
We've got low pressure throughout the house(outside is fine), and when I bypass my WHES44, all pressure returns. I put the thing in Brine cycle yesterday, as the tank was 1/2 full of water.
That successfully got all the water out, and I did a manual recharge, which, when finished, never got the new water out.
So I'm back at it today, cleaned the venturi assembly again, and now I'm lost....
When in brine mode, with the nozzle off the venturi assembly, it sucks air, very weakly for 5 sec(when bypass is pulled out of course), then begins to spit water out of the assembly!! So it's not sucking anything at this point.
I'm not sure what happened inbetween yesterday and today, but now its not sucking anything at all in brine mode, actually the opposite!!
Any help is greatly appreciated
We've got low pressure throughout the house(outside is fine), and when I bypass my WHES44, all pressure returns. I put the thing in Brine cycle yesterday, as the tank was 1/2 full of water.
That successfully got all the water out, and I did a manual recharge, which, when finished, never got the new water out.
So I'm back at it today, cleaned the venturi assembly again, and now I'm lost....
When in brine mode, with the nozzle off the venturi assembly, it sucks air, very weakly for 5 sec(when bypass is pulled out of course), then begins to spit water out of the assembly!! So it's not sucking anything at this point.
I'm not sure what happened inbetween yesterday and today, but now its not sucking anything at all in brine mode, actually the opposite!!
Any help is greatly appreciated