Brian Corcoran
New Member
- Messages
- 1
- Reaction score
- 0
- Points
- 1
Looking for advice on which way to pipe an HTP - SSU-30 Indirect Hot Water Heater to the Alpine - Alp-080.
Heat Load Calculations run on house. This is an Oil to Natural Gas Conversion. House is 1,400 Sq/Ft, 3 Zones (via circulators) of slant fan hydronic baseboard = basement play room, first floor, and attic bed room. One Bathroom, Dishwasher, Washing machine ( typically -wash on warm cycle). 5 folks - in household , 3 female teenagers - 2 away at college.
The Burham Alpine installation manual provides - 2 piping scinarios/options.
* Install IWH Circulator right off of the near boiler header
* Install IWH Circulator on the Secondary Loop along with the heating zone circulators.
Please advise best pipping option and why?
Thanks,
Brian C.
Heat Load Calculations run on house. This is an Oil to Natural Gas Conversion. House is 1,400 Sq/Ft, 3 Zones (via circulators) of slant fan hydronic baseboard = basement play room, first floor, and attic bed room. One Bathroom, Dishwasher, Washing machine ( typically -wash on warm cycle). 5 folks - in household , 3 female teenagers - 2 away at college.
The Burham Alpine installation manual provides - 2 piping scinarios/options.
* Install IWH Circulator right off of the near boiler header
* Install IWH Circulator on the Secondary Loop along with the heating zone circulators.
Please advise best pipping option and why?
Thanks,
Brian C.