have a vacation home that I just had built in Mexico. It's in the Riviera Maya region, which is nothing but limestone. I had a hard time finding a kinetico water softener. My dealer was able to get one from a the other side of the country. They know absolutely nothing about them. They hardly ever use water softeners down here even though the water is hard.
I I need help setting this up. They sold me the Mach 2030s softener. It is just my wife and me living there. So not a lot of demand. I had a 50 micron pre-filter installed before the softener. The system came with a number 4 disc. The float is set at the second mark from the bottom. I don't believe this is correct. I had my water tested. Ithad 20 grains of hardness. No iron. No chlorine either.
Any advice as to where a good starting point would be. What number disc and where the float height should be. Also what letter to cut to below the float. Thanks for any advice. I am on my own with this down in Mexico.....
I I need help setting this up. They sold me the Mach 2030s softener. It is just my wife and me living there. So not a lot of demand. I had a 50 micron pre-filter installed before the softener. The system came with a number 4 disc. The float is set at the second mark from the bottom. I don't believe this is correct. I had my water tested. Ithad 20 grains of hardness. No iron. No chlorine either.
Any advice as to where a good starting point would be. What number disc and where the float height should be. Also what letter to cut to below the float. Thanks for any advice. I am on my own with this down in Mexico.....