jdmag00
New Member
First off thanks for any and all responses, I decided to do a laundry/bath reno DIY and have zero plumbing experience. To make a long story short the line going to the right off the sanitary tee goes to a washing machine, with vent, which ties into the vent for shower and onward to stack. The drain in the center of the picture is for a shower, these tie into an existing 2in that runs about 3ft to a 3in wye into the main drain line. The issue is I have since learned I am not allowed by code to use a tee in this manner (I hope thats my only screw up). I have since leveled this floor and covered it with DITRA heat matt, and put in a shower pan and curb. My question is should I just break it all up and do it right? Or is that not that big of a deal ( Yes I know its not right ). I believe the correct way of doing this, and what I should have done was extend the 3in and connect the two 2in drains to that using proper fittings.
Thanks
John
Thanks
John