I have purchased and installed a Fleck 7000SXT 80k softener and I'm ready to test it out.
Note: I will be purchasing a separate iron filter in the near future but needed to get softener up and running because my slowly dying unit finally died. I'm assuming I'll have to tweak settings after that but I'll deal with that later.
Stats:
4 person household
Well Water
10 GPM Flow Rate
Iron: .81 ppm
Manganese: .08 mg/L
Magnesium: 45.00 mg/L
pH: 7.75 SU
Turbidity: 0.79 N.T.U.
Color: 5.0 C.U.
Odor: none
T.D.S.: 554.4 mg/L
Sediment: none
Hardness: 25gpg
Sulfate: 24.73
I haven't really seen any straightforward advice on programming so I'd thought I'd ask my fellow experts.
I'm assuming I would set the hardness to 30gpg to adjust for the iron?
Note: I will be purchasing a separate iron filter in the near future but needed to get softener up and running because my slowly dying unit finally died. I'm assuming I'll have to tweak settings after that but I'll deal with that later.
Stats:
4 person household
Well Water
10 GPM Flow Rate
Iron: .81 ppm
Manganese: .08 mg/L
Magnesium: 45.00 mg/L
pH: 7.75 SU
Turbidity: 0.79 N.T.U.
Color: 5.0 C.U.
Odor: none
T.D.S.: 554.4 mg/L
Sediment: none
Hardness: 25gpg
Sulfate: 24.73
I haven't really seen any straightforward advice on programming so I'd thought I'd ask my fellow experts.
I'm assuming I would set the hardness to 30gpg to adjust for the iron?