NBachers
New Member
I work in the plumbing department of a local home care center. From time to time, people need to cap off a 1/2" angle stop, or the water inlet where the supply line connects under the faucet. It's 1/2" thread, but a 1/2" pipe thread cap won't fit. It's not compression; I have those. It's closer to 1/2" MIP. I have expensive chrome caps that work, but I need a utility cap that'll fit. Can anyone help me with:
1. What is the actual name of this thread?
2. Do you have any sources for the caps that will work?
Thanks, Neil Bachers
1. What is the actual name of this thread?
2. Do you have any sources for the caps that will work?
Thanks, Neil Bachers