Hello,
i have a old deep cast iron crane sink with the curved back where the faucets and handles come out in the middle of the sink. the curved part is plastic where the faucet comes out. The problem is that the faucet has a three connection fixture on the bottom of the faucet and above that is the brass nut that tightens down the faucet to the curved part of the sink.
i cannot get a sink wrench up there to tighten the faucet. And I am not sure if I can replace it with a new faucet that has one fixture coming out that will remove the mess of hoses and connections. Any ideas. Thanks.
i have a old deep cast iron crane sink with the curved back where the faucets and handles come out in the middle of the sink. the curved part is plastic where the faucet comes out. The problem is that the faucet has a three connection fixture on the bottom of the faucet and above that is the brass nut that tightens down the faucet to the curved part of the sink.
i cannot get a sink wrench up there to tighten the faucet. And I am not sure if I can replace it with a new faucet that has one fixture coming out that will remove the mess of hoses and connections. Any ideas. Thanks.