Search results

Hello All, I was gluing a 3" PVC pipe into the bottom of a PVC flange. There is no obvious stop, so I was hoping to slide it in 2". Upon gluing it, it got stuck at 1". This is less then the 1.5" a 3" pipe normally goes in. Before I rip it out and start over, how far should a pipe slide into...

Hello All, I do not have a picture so hopefully this makes sense. I have 3/4 copper supply lines running across my basement. Right now there is a tee in the middle that has a vertical pipe that rises 4 inches, then an elbow and the 3/4 copper runs perpendicular to the original supply lines...

Hello All, This is a followup to a previous post. It was suggested that my new shower should be installed as per the diagram below. But I am working in a soffit, so there is no room to add another sani tee. Can I use the existing sani tee from the lav and add a double quarter bend to connect...

Hello All, I am adding a new tub (will be vented) to an existing bathroom and wanted some thoughts. See below, but basically the shower is separated from the stack by the toilet. I see three options (marked as A, B, or C). In your opinion, what is the best option, and are any of these...

Hello all, Thank you for the past advice on this project, but covid delays have made me reconsider. So here is my new question. Is it possible to connect this shower to the toilet horizontal 3"? I was thinking it would be from the 2" shower into a 3" wye rotated 45 degrees. I think the...

Hello All, Before I bring a plumber in, I would like to know if this is OK, or can be improved. This is an upstairs bathroom, and the plumbing is in a soffit that I would like to shrink in size. I noticed that the toilet horizontal pipe does not have a vent prior to when it turns vertical...