Search results

After few backwashes it cleared up. Thank you

Did that, worked perfectly. Thank you

When I got my well water test results I noticed Gross Alpha is elevated but divided into Gross Alpha Initial and Gross Alpha Final. What is the difference between them ? Also each have different Applicable standards (maximum contaminant levels). Is Gross Alpha Initial totally different than...

I just replaced my AN with brand new tank and valve. After bw and rr my water comes out cloudy almost white. Any ideas why is this happening?

That was my plan to fill it up before valve is installed and let it stay for 72hrs but after that I have seen on videos people flashing it with water - first through in line for 15min and then out for 6 min. How can I do that flash after it soaks for 3 days with 2510 sxt mounted ? or is it...

I'm planning to rebed my carbon filter with 2510 sxt valve but all YouTube videos I have seen only show in/out valves and they recommend flashing with water in and out ports. How can I flash 2510 sxt before I run it through my house and softener ?

I'm trying to figure out what is going on with my well water and softener. I keep getting those rust spots on my utensils and I cant figure out what is causing it. I have tried few water softener companies and they all have not answers. Also last year I redid my water manifolds and year later...

Actually I'm not using injector at this moment. My iron levels are <0.20 mg/L (applicable standard is 0.3) and Manganese 31.8 ug/L (applicable standard is 50).

I just updated my diagram. Other picture is constant pressure system that goes into softener. I don't see any pressure switch. The on from retention is flow switch for injector ( I think )

It started same day or next after refill. How can I check gpm on my system ? Also I made a diagram ( chlorine injector is included but Im not using it since my iron levels are low )

I did. Didn't help much. Also I just checked last years water test and out well pH levels are 4.59

I closed both valves on AN and pressure is amazing - any ideas what wrong with that tank ?

Sorry picture was taken prior turning that valve. What happens if I only turn the one I marked?

AN and Carbon tank sizes are 10x54 PG 2.5"T Softener 2 tanks are 14x65 - what is your recommendation for AN and Carbon tank vales that don't limit drain flow ? - On the picture I attached is the valve I closed to bypass AN (I hope it is correct one but pressure increased a lot). It seems like...

Neutralizer has backwash valve. I didn't know I can bypass individual tank.

My water pressure started to act up right after company added neutralizer. When I turn on water it will go almost normally but within seconds starts to drop pressure. I can't use sink and shower at the same time. When I bypass softener pressure is constant and strong. Any ideas what is...

ok so I tested both hot water and cold for hardness and both came back 1 gpg. when testing for iron - cold came back 0 ppm and hot 0.15 ppm why would hot water have iron and cold not ???? kitchen knifes are attracted to magnet

No visible rust anywhere in dishwasher. When water was tested today they checked water before softener ( direct from well ) and then from faucet - cold and hot. Only hot water showed visible iron levels in test tube.

We had bran new Clack water softener system installed last Sep. Also new Weil-Mclain boiler Ultra S4 and few months ago brand new indirect fired water heater Weil Mclain Aqua pro 80. Recently we noticed that dishwasher rust stains on out flatware. Our well water test showed Iron <0.20 mg/L...

Hi guys Im new here. I hope you can help me up. I have a fleck 9500 in a house we recently bought. The is a leak from valves and sensor. My water test came back with numbers all over the place. This system was neglected and water wasnt used for months. Here's the numbers I had too high on our...