Search results

Is there anyone in the forum with experience regarding explaining possible reasons for error codes on an Enter Tech water to air system? Thank you

What would be the main reason my tub will not hold water with the stopper closed? No build up of hair or gunk around the o'ring or in the drain below. Water drains out over an extended period of time as opposed to quickly. Thanks for any replies.

I posted this in the Landscape forum before seeing this forum and will try to delete it from there if possible since my question clearly belongs here. I need to adjust and probably replace several heads due to installing some garden boxes and a deck extension to minimize water waste. my first...

I need to adjust and probably replace several heads due to installing some garden boxes and a deck extension to minimize water waste. my first thought is to change the coverage pattern and reduce the throw distance to see if I can stop needlessly watering the boxes and deck. To do so requires...

Facts: 1. Single story home built in 2019 with city water supply. 2. 60 psi pressure at nearest and farthest hose bibs from pressure regulator at move in. 3.Hot water tank has expansion tank. 4. Current pressure at same two bibs is 51 psi. 5. No leaks in any visible locations( city main meter...

Can anyone tell me the name and type of combination 90 degree fitting shown in the pictures? Can I reuse them and if so do I need a special tool to remove them from the blue pex pipe collar they are attached to? I need to move two irrigation heads about 2' from where they currently sit and I...

Controller and all valves are Rain Bird brand. Controller is testing normal at 24 volts ac. No zone will operate in either manual or auto mode unless I disconnect the black wire supply from the controller to the black wire on the master valve solenoid and open the valve flush then all zones will...

Moen Eva type handle jiggles on valve shaft. Set screw inside of handle is tight. Any idea why there is play in the handle. Installed new in December of 2019. Thanks for any replies.

Unlike homes built to withstand and function where freezing is an every year ritual, it is not the usual case here in Austin. Long story short, the water provider is about to shut the entire system down and restore service sometime tomorrow. My home does not have a low water point drain to...

Need help determining how to lubricate the lever so it doesn't stick in the flush(down) position. The chain attaching the flapper to the lever is not kinked causing the issue. Biggest concern is breaking the screw on the linkage assembly closest to the black plastic nut inside the tank and...

The drain assembly on the large bowl(opposite the one connected to the disposal) is less than two years old. When cleaning the sink and drain yesterday I noticed the drain spin when I was cleaning with a sponge.A couple of hours later I heard a drip sound and when I looked at the underside I...

I just replaced a dripping valve with a new one and it has a small drip from inside the thread body of the valve. I have tightened the valve pretty tight and ma afraid doing so any further might crack it. I did not use any teflon tape when initially installing it and am wondering if removing the...

Residence: 2 story home built in +/- 1996 in Austin,Texas 2 natural gas hot water tanks both located in two different attic spaces above 2nd floor ceilings. Older of the two definitely feeds the kitchen and all bathrooms.It has gradually starting making increased "grumbling/gurgling" noises as...

I am attaching a picture of my tub valve to ask if and how I can remove the cold water inlet handle assembly(left handle in picture) and move the stem assembly clockwise until the off position is in the same position as that for the hot water side. Do I need any special tools to do so? Thanks...

This is my first post so forgive me if I inadvertently break any rules. I have a Moen two handle Monticello Roman Tub valve installed in 1996. The cartridges are still good but the handle on the cold side turns past the stop position and will turn completely around. I have verified that the...