Search results

Thanks for the advice. This is the original plumbing except at one time maybe 20 years ago I had to re-do some of it to fit the position of the new sink. I followed the original design except lengthening or shortening a couple of straight pieces. I will consider reworking it per your...

That's what we do, but it's annoying because we have a dish dryer in that sink and sometimes it has a lot of wet dishes at the same time you want to use the disposal. If we forget to remove the dishes, then they get covered in debris.

Update: As suggested by @Reach4 the Tee already has the baffle. @Reach4 also suggested there might be a P-trap and fortunately I have a basement with a drop ceiling so I checked and there is a P-trap. I used a powered drain snake on the P-trap and when finished, the end of the snake was...

As the title says, when the disposal is on, water/debris comes out of the adjacent drain, enough to get on items drying. The disposal is nearly new, but the previous disposal did it too so this has been going on for a long time. We don't purposely put grease or produce in the disposal, just...

I would like to replace this hardware with a different finish, unfortunately the tub is not accessible from the underside without tearing out the tile. Any chance this is Price Pfister? The shower and tub valves in other areas of the house are Pfister. House was built about 1994. Thanks...

I have a vague idea where the line runs, no idea where the vent line is. After reading some other posts, I can see this is not a good idea, I'll just leave it where it is.

I'm working on a basement shower. The 2" PVC drain (in the concrete foundation) is in one corner of the shower, and I'd like to move it to the center. Measured from inside the drain, the existing drain drops 10.5" below the concrete surface. I plan to rent a concrete saw and cut a channel...