frank coviello
New Member
- Messages
- 6
- Reaction score
- 0
- Points
- 0
Newbie here. I have two toilets that are in seperate rooms and one wall seperates the toilets. One of the toilets had a problem with the fill valve so I drained the tank, turned off the water valve and took out the old fill valve. The only part I left was the part that was screwed into the bottom of the tank. Purchased a replacement fill valve, installed it properly and when I went to turn my water valve back on the tank started to slowly fill but there was alot of clunking and vibrating in the valve and pipe. It seemed like the pipes had run dry of water or something like that. Tried it a few more times but the clunking continued. My wife came home and I wanted her to hear the clunking and when I went to turn the water valve on this time absolutely nothing happens. No clunking, no vibrating and no water. It seems to me like the pipe has gone dry. The other toilet in the other room seems to be working just fine. No problems or clunking with that valve when I turn it on and off. I just don't have a clue where to go with this one.
Any suggestions? Thx.
Any suggestions? Thx.