Hello,
I’m observing something really strange: my softener arrives to the end of the regeneration cyclle with no hardness leakage at all (measured at 0 gpg). However after a regeneration cycle, the first 2-5 gallons register 2gpg to fall again to 0 gpg after that remaining as such until end of cycle. Any ideas what could provoke this?
water is municipal service, no iron, regeneration with sodium chloride .
softener is a less than one year old fleck 5800 xtr2, 1ft^3 media. It is set up for fill first. my settings are, salt dosage (7 lbs/ft^3), tank refill refill (18min), pause (120m),draw(70 min), fast rinse (8m) backwash (7min). BLFC is 0.125
thanks so much in advance!
I’m observing something really strange: my softener arrives to the end of the regeneration cyclle with no hardness leakage at all (measured at 0 gpg). However after a regeneration cycle, the first 2-5 gallons register 2gpg to fall again to 0 gpg after that remaining as such until end of cycle. Any ideas what could provoke this?
water is municipal service, no iron, regeneration with sodium chloride .
softener is a less than one year old fleck 5800 xtr2, 1ft^3 media. It is set up for fill first. my settings are, salt dosage (7 lbs/ft^3), tank refill refill (18min), pause (120m),draw(70 min), fast rinse (8m) backwash (7min). BLFC is 0.125
thanks so much in advance!
Last edited: