Frost
New Member
Howdy!
This is our first Fleck install and we want to make sure we configure it properly. Let me know if I forget any crucial information. I did a quick search for the 5812 and saw the thread regarding a similar-sized unit with a different injector - so didn't want to use those settings directly (without checking you know).
Use:
Hardness - San Diego city water - GPG ~ 17 (from city water reports)
People - 3 adults in the household (new construction, not positive on exact water use yet)
Softener:
Model - Fleck 5812 SXT w/ 13" x 54" resin tank (2.5 cu ft)
BLFC - 0.5 gpm
DLFC - ? (3/4" BLANK was shipped *maybe* in error, so we'll request the recommended from the supplier)
Injector - #2 (blue)
Any advice is much appreciated, we are planning on running a 3/4" PVC drain line, and think we should request the 4 gpm DLFC button but want to double-check on that as well.
Thank you,
Christopher
This is our first Fleck install and we want to make sure we configure it properly. Let me know if I forget any crucial information. I did a quick search for the 5812 and saw the thread regarding a similar-sized unit with a different injector - so didn't want to use those settings directly (without checking you know).
Use:
Hardness - San Diego city water - GPG ~ 17 (from city water reports)
People - 3 adults in the household (new construction, not positive on exact water use yet)
Softener:
Model - Fleck 5812 SXT w/ 13" x 54" resin tank (2.5 cu ft)
BLFC - 0.5 gpm
DLFC - ? (3/4" BLANK was shipped *maybe* in error, so we'll request the recommended from the supplier)
Injector - #2 (blue)
Any advice is much appreciated, we are planning on running a 3/4" PVC drain line, and think we should request the 4 gpm DLFC button but want to double-check on that as well.
Thank you,
Christopher