Jazzman
Member
I’m in the middle of replacing rusted out 300 gallon tank with 1000 gallon norwesco low profile tank that meets code. Because of the size of new tank and slope of property I had to set tank inlet about 12” below where it entered old tank. I know you want to have 1/4” per foot slope from house to tank but I was wondering if I could I could install 22-1/2 degree fitting 3-4’ from tank and then slope line at 45 degrees before it enters tank? Would that meet code? Other wise I would have to excavate the whole 25’ of line and lower it where it leaves the house.
Thanks
Thanks