I found a white sticker on the head. It shows:
BLFC = 0.125 GPM
DLFC – GPM
Also note that when I started the re-gen the other day, there was approximately 4 gallons of water solution in the brine tank, just under the plastic deck. I added 1 gallon to make it approximately 5 gallons. So I re-gened with 1 extra gallon (not 1 gallon total).
I believe because of the additional 1 gallon of water I added, the final capacity reading went from 1909 to 2326. I just checked again and there is water to the bottom of the deck, so I’m thinking there is still 4 gallons in the brine tank.
What is the Grid plate ? Is that the plastic "deck" at the bottom of the brine tank ? If so, I did observe salt in the feet.
Also, if the BD cycle is 60 minutes and I only observed 13 minutes of flow, shouldn't there be more water to draw from or the cycle reduced ?