teke
New Member
I am currently working on a one level ranch and have been renovating a full bathroom and a Kitchen. The main vent stack is 3 inches (pvc) and goes through the roof. The bathroom is vented through this 3 inch vent stack . The main stack is not a straigth run, it goes up through the attic and has an elbow then runs 8 feet horizontally and then another elbow up to the pipe that exits through the roof. the entire run for the bathroom vent is 3 inch pvc (sloped back to the bathroom).
I also would like to vent the Kitchen sink / dishwasher through the same 3 inch stack. The Kitchen sink and diswasher use a 2 inch pvc for the vent. My challange is the vent pipe for the kichen comes to the main stack from a different direction (180 degrees.)
My question is how can I tie the kitchen sink into the 3 inch mainstack. Could I remove the elbow and use a 3 inch tee on its back feed the sink vent from one side and the bathrom vent from the other?
Thanks in advance for your suggestions
I also would like to vent the Kitchen sink / dishwasher through the same 3 inch stack. The Kitchen sink and diswasher use a 2 inch pvc for the vent. My challange is the vent pipe for the kichen comes to the main stack from a different direction (180 degrees.)
My question is how can I tie the kitchen sink into the 3 inch mainstack. Could I remove the elbow and use a 3 inch tee on its back feed the sink vent from one side and the bathrom vent from the other?
Thanks in advance for your suggestions