pls2000
New Member
I've got an odd situation with a kitchen sink faucet. I need a 90 degree turn at the faucet to attach the supply risers.
There is enough flex in the risers to do it, but rather than stress them with a sharp turn, I'd rather use an elbow.
Does anyone make an elbow with the right threads to fit a 1/2 inch faucet connection and an 1/2 female riser? Just to state the obvious, the threads are not NPT, they are NPS.
Thanks.
There is enough flex in the risers to do it, but rather than stress them with a sharp turn, I'd rather use an elbow.
Does anyone make an elbow with the right threads to fit a 1/2 inch faucet connection and an 1/2 female riser? Just to state the obvious, the threads are not NPT, they are NPS.
Thanks.