Future2024
New Member
Hello all,
Yesterday, I noticed my Clack WS1 water softener starting its regeneration cycle at midnight. This causes me to investigate:
1) I realized my regen setting was "on 0". Changing it to "NORMAL" or "NORMAL + on 0" unlocks the option to set regen time 2am. Should I change it to 4am or something? Don't want to not have soft water at midnight or 1am since I may still be up.
2) Switching between post-fill and pre-fill settings also proved impossible. The manual suggests pre-fill starts the cycle two hours early, explaining the midnight noise. However, options to change this setting weren't available in the "NEXT + DOWN" pages. What gives...?
Should I attempt to change the behavior from pre-fill to post-fill?
If it's helpful here's my other settings:
Thanks to all experts in advance.
Yesterday, I noticed my Clack WS1 water softener starting its regeneration cycle at midnight. This causes me to investigate:
1) I realized my regen setting was "on 0". Changing it to "NORMAL" or "NORMAL + on 0" unlocks the option to set regen time 2am. Should I change it to 4am or something? Don't want to not have soft water at midnight or 1am since I may still be up.
2) Switching between post-fill and pre-fill settings also proved impossible. The manual suggests pre-fill starts the cycle two hours early, explaining the midnight noise. However, options to change this setting weren't available in the "NEXT + DOWN" pages. What gives...?
Should I attempt to change the behavior from pre-fill to post-fill?
If it's helpful here's my other settings:
- (NEXT and DOWN)
- Softening
- <cycle settings>
- 26K capacity
- REGEN:
- AUTO GAL
- on 0 <--- this was the setting making me unable to set 2am time
- rELAY: oFF <--- no way to change pre-fill or post-fill; and I don't understand what these are (not in manual?)
- CALL: oFF
- (NEXT and UP)
- 14 days between regen
Thanks to all experts in advance.