donk
Member
- Messages
- 34
- Reaction score
- 0
- Points
- 6
Hello - I'm about ready to tap into my under-sink Kitchen cold water supply, to install an icemaker.
The supply coming out of the wall is a 1/2" plastic pipe. Here's a pic of it:
http://tinyurl.com/2qzkqk
It appears that the current, plastic stop valve is screwed into the plastic pipe. The new stop valve I have is brass. My question... can I just screw my new brass valve into the plastic supply pipe - where the plastic valve is now attached?
If not, what fittings do I need to make the plastic supply pipe coming out of the wall compatible with my new brass stop valve?
Thanks for any suggestions,
Don
The supply coming out of the wall is a 1/2" plastic pipe. Here's a pic of it:
http://tinyurl.com/2qzkqk
It appears that the current, plastic stop valve is screwed into the plastic pipe. The new stop valve I have is brass. My question... can I just screw my new brass valve into the plastic supply pipe - where the plastic valve is now attached?
If not, what fittings do I need to make the plastic supply pipe coming out of the wall compatible with my new brass stop valve?
Thanks for any suggestions,
Don