Dave2500
New Member
Hello all,
I’m on well water and currently have an Aqua science acid neutralizer that is OF the backwashing type.
I’m looking to upgrade to a tank with a side hole so I can add it without pulling the top off nonstop and at this point the aqua science one is around 13 years old.
The current one is using a mix of calcite and corosex, but im hopeful i can switch to calcite only? so i dont have to mix them?
I’m looking for opinions on which one to go with, the one distributor I am dealing with really recommends a NON backwashing one, but from what I’ve heard those are prone to getting channels in them?
Any recommendations? (Well pump is around 25gpm, but I never pull 25gpm if that even matters)
(All the readings were taken BEFORE the acid neutralizer and water softener)
Hardness GPG: 9.5
T Iron: 0.0
Ferrous: 0.0
Ferric: 0.0
Copper: 0.4
Nitrite: 0.0
Nitrate: 7
I’m on well water and currently have an Aqua science acid neutralizer that is OF the backwashing type.
I’m looking to upgrade to a tank with a side hole so I can add it without pulling the top off nonstop and at this point the aqua science one is around 13 years old.
The current one is using a mix of calcite and corosex, but im hopeful i can switch to calcite only? so i dont have to mix them?
I’m looking for opinions on which one to go with, the one distributor I am dealing with really recommends a NON backwashing one, but from what I’ve heard those are prone to getting channels in them?
Any recommendations? (Well pump is around 25gpm, but I never pull 25gpm if that even matters)
(All the readings were taken BEFORE the acid neutralizer and water softener)
Hardness GPG: 9.5
T Iron: 0.0
Ferrous: 0.0
Ferric: 0.0
Copper: 0.4
Nitrite: 0.0
Nitrate: 7