Search results

Thanks. I'll do it.

Thanks. Seems the thermostatic mixing valve can mix cold and hot water instead of control the temperature inside the hot water tank? what I worry is what bad thing can happen if the temperature inside too high. Also, is that possible to DIY a control board by Arduino to replaced the Rodgers 927?

The White-Rodgers-37E73A-918-Intelli-Vent-Control on my water tank had been changed two times in the past 6-7 years, and it is not control the temperature again. The hot water becomes too much hot than usually， is this normal ? or what's the problem? Can do any repair on it? Thanks Adam

The tool looks nice, seems it's step is quite big, as I need expand 1mm OD, one step should be fine I guess.

Thanks for all replies. I'm trying to order on eBay by: BTW, any interesting on the expand work? Best Adam

Because I didn't know it is what I need when you posted the link, I asked the seller about, he can't tell what ID it is. I know now the ID is fit to 1/2 tube's OD. Thanks Adam

So it is perfect for me. Thanks Adam

I made a mandrel or die like the picture attached and try to expand the tube end, any one has the experience on this, can I just use one die to expand it one time or may need step by step? Thanks Adam

Yes, it is what I need, the thing is the seller can't be able to tell me what the ID size is.

Thanks , is this “Sioux Chief 5/8 in. Sweat x 5/8 in. Dia. Sweat Copper Repair Coupling” mean it has a 1/2 ID (Inside Dimension) ? I need slid it on a 1/2 tube. Thank you Wayne, I try to confirm the ID of it in the link, nobody answer yet. Best Adam

Hello every one, I am new here, thanks for any help. I'm looking for a copper tube ID = 5/8 " (15.875mm) , mean it can tightly sheathed outside the nominal size 1/2" tube which is commonly used at home. I found the piece at Home Depot like the T here...