Search results

Thanks for your responses. With resopect to the gravel - does what I have in the picture work? This is what I excavated from the hole.

Based on feedback from the forum, there was a suggestion that a high water table might displace this basin once its put in place. I took a look at the neighbour's setup, and he has a sump pump adjacent to the sewage pit. So I am thinking I will do the same - as I have seen water rise and receed...

Here is a picture of what I have currently. Will using elbows on the discharge be a possibility?

thanks - looks like the roughed in discharge is higher than it should be? I am not sure if there are standards around this. I assumed that all basins would have this hole at the same spot. Hopefully a pro responds. Thanks again for your advice.

Thank you - the discharge line under the concrete is now fully lined up with the side hole in the basin. How would I lower this discharge line? Some kind of an elbow?

I am dry fitting the sewage basin. Based on the position of the discharge line and the hole in the basin, this is what I am ending up with. The basin is protruding about 4 inches above the floor. Is this normal or shoud I find a way to lower the discharge line? Appreciate your advice.

Would this situation be legal? There is about 3" between the ABS and the wire.

Thanks. With respect to the slope, can I instally a fernco coupleron the vertical piece? This way, I cab tilt it to guarantee that te slope is present.

Thanks. This is for a Basement Toilet, Shower and Sink - nothing else will discharge here. I bought the Flotec 3/4 HP Sewage Pump. Assuming thatthis is good? Regarding changing the pump - is this with regards to moving the pipes? Any ideas on how I can make the Vent easily movable? I am...

Wondering if I can get some feedback on this set up before I start glueing things together. Any feedback will be appreciated. Thsi will all be ABS piping. I am also tryong to figure out with type of fitting will give me the slope at the top - the red circle.

Thank you - the current plumbing is ABS.

I am in Ontario. Should I be using PVC or ABS for my Sewage Ejector Pump? The Home depot recommended ABS, but I have seen videos online with PVC.

I am now trying to figure out the venting for my sewage ejector pump. I broke the ceiling over the pit if there was anything thre - its empty. I broke a hole in the room cieling adjacent - about 3 feet away from the sewage basin, and found the picture attached. I belive this is the vent - it is...

Thanks James - sorry I am probaby playing above my league here, but can you explain how I will use the 2 45's?

I am in the process of installing my sewage basin in the basement. See picture attached. 3 questions: 1. How much gravel and how much concrete do I need to put around the bin? Should the concrete be about the same thickness as the basement floor? 2. I will be plumbing the pump to go straigh up...

its brand new - this has never been used - its a new install. Yes there are 2 hles on the lod - one for vent and one for the pump.

Why do you think so? Appreciate your thiughts. The plan is to bury this in this in the pit.

Thanks for your advice - I might be out of my league here, but I am still unsure of how to proceed. @Reach4 - thanks for engaging in this. I am uploading a picture - hopefully this helps to clarify my concern. The picture shows the pit - the inlet from the toilet/shower/sink is on the right -...

Just to clarify. I have an empty pit currently - just a hole in the ground. (Sorry I might be useing the wrong words). I am now in the proces of putting the basin into the pit. I was not planning to put holes in the basin as I was made to understand that is not correct. So the concern is - once...