Search results

  1. OklahomaDave

    Pfister faucet, Finding right stem/cartridge for the original

    I have an original single-handle shower faucet that I believe is failing, allowing cold supply water to run across to the hot side and make the temperature almost impossible to control (hot water barely lukewarm). The faucet is shown in the first pic. I believe it is a Pfister 971-250. But I...
  2. OklahomaDave

    NG Water Heater replacement: Reuse copper flex feed lines?

    Hi all.. I am getting ready to replace our original, 20-year-old Bradford White water heater. The installer hooked it up during construction to the house water with copper flex lines, and I have heard differing opinions on whether it's a good idea to reuse them on the new tank. I am planning to...
  3. OklahomaDave

    Securing disposal flange on new stainless sink

    Greetings! I have just completed the reinstallation of a garbage disposal into a new stainless sink in our kitchen, and while the install appears to have been successful, I am concerned about one thing. The previous sink into which this disposal was installed was essentially flat on the...
  4. OklahomaDave

    Moving shutoff line...doable?

    I'm in the midst of a kitchen remodel, and in working out the installation of a disposal within a new, deep sink. My supply lines come up through the floor into my cabinet space. Each supply line is terminated with a fairly typical compression cutoff at the top. Given the depth of the new sink...
Top
Hey, wait a minute.

This is awkward, but...

It looks like you're using an ad blocker. We get it, but (1) terrylove.com can't live without ads, and (2) ad blockers can cause issues with videos and comments. If you'd like to support the site, please allow ads.

If any particular ad is your REASON for blocking ads, please let us know. We might be able to do something about it. Thanks.
I've Disabled AdBlock    No Thanks