Search results

I'm trying to source a replacement for this vinyl bulb seal that slides into a T-slot on the strike jamb of a builder-grade glass shower door frame. The bulb is very thin so that is flexible enough to compress under the force of the magnetic door catch. Most similar products I've been able to...

Looking to see if anyone has a source with known stock of a 61956-01 Piston & Seal Assembly for a Fleck 5810 water softener valve. My water softener has been out of service for over a month because I am unable to find this part. I have it on order with two suppliers, but promised delivery...

I think I understand the principles, but I don't do this often so just looking for someone to check over my planned settings to make sure I didn't screw something up. I've based this on a using a 7.2 lb/cuft salt dose to achieve 22,700 gr/cu-ft capacity which gives me a total system capacity of...

I have a Fleck 5812 SXT that I bought and installed in 2017. When I woke up this morning I heard water running down my washing machine drain where the softener drains which was odd since the regen cycle should have been done hours before. I checked the display and there was no error code. I...

Do the settings below look correct? Seems like the capacity should be more like 60,000 grains to be closer to the "ideal" salt dose of 8 lbs per cu-ft (@24,000 grains/cu-ft). What actually controls salt dose? I assume the BLFC and Injector have a role, but do any of the settings affect it...

I'm looking for advice on replacing a Culligan Medalist Plus Model 30 water softener installed in the 2006 timeframe. It is not completing the regeneration cycle due to E1 and E2 errors. Not sure if it's a sticking filter pack or a weak motor. Sometimes I can get it to complete the cycle if I...