Search results

  1. Johndoejohndoes

    Only One AAV in Master Bathroom (2 Sinks/1 Shower/1 Toilet)

    I have one plumbing vent coming out of my roof by the laundry room which ties into the drain going out to the sewer. Everything else connects underground to that drain going out to the sewer…but I notice in every bathroom (under every sink) there is an AAV. In the master bathroom, I have two...
  2. Johndoejohndoes

    Is AAV fitting too big? Why do all mine look like this?

    I was taking a look at the AAV on my sinks and the fitting looks too big on the piece connecting the AAV. I looked underneath and see this…not sure if this is normal and sealed properly?
  3. Johndoejohndoes

    Difficulty closing sink drain. The drain lever is pressing up against this water supply line. Any advice?

    I notice that my sink drain is a little difficult to open and close. I looked underneath and saw the water line was run above the lever where the drain opens and closes…essentially the line is getting pushed by the little metal bar each time the sink is opened and closed since the metal bar...
  4. Johndoejohndoes

    Question about new Uponor PEX Plumbing Install

    I had a few questions about a new Uponor PEX plumbing install for my new construction home. I’m building in Florida and the plumbing is under the slab (one story house). Here’s how everything looked before the slab was laid. 1. As you can see above, most of the Uponor AquaPex is the white...
  5. Johndoejohndoes

    Is my PEX going to be exposed to UV for too long?

    On February 10th my new construction home had Uponor PEX laid into the ground under our soon to be slab location. On my follow up visit on February 20th everything was covered with dirt and there was a tarp over it…so it was exposed to direct sunlight for no more than 10 days. For most of the...
  6. Johndoejohndoes

    Which BrassCraft To Get - Replacing Valves

    I'm looking to remove and replace the cheap Accor FlowTite Shut Off Valves at my toilets/sink and I'm trying to determine which BrassCraft will suit me best. I have PEX in my house - does anyone have recommendations on which part I should get from Home Depot? I'm not very experienced so I may...
Top
Hey, wait a minute.

This is awkward, but...

It looks like you're using an ad blocker. We get it, but (1) terrylove.com can't live without ads, and (2) ad blockers can cause issues with videos and comments. If you'd like to support the site, please allow ads.

If any particular ad is your REASON for blocking ads, please let us know. We might be able to do something about it. Thanks.
I've Disabled AdBlock    No Thanks