Search results

  1. k-n

    Meter panel with external knife cutoff?

    I'm not sure if I'm searching with the right terminology. I'm looking for a meter panel (320A+) to replace the current panel that feeds two smaller panels. I am installing solar and the rules here are that I have to have an external cutoff that removes my solar from their grid in the event of...
  2. k-n

    Adjust my pressure switch or install my CSV?

    My system is 3HP well pump that pumps to a 2500 gallon cistern. From the cistern I go to a goulds J10s 1HP electric. My original plan was to put a CSV in to keep the goulds running at 50PSI constant. My issue is I have an 86 gallon AO Smith pressure tank and the CSV is supposedly supposed to...
  3. k-n

    Chasing a flickering gremlin

    My house was rewired by a licensed electrician roughly a year ago. We have everything new from the utility pole into the house an all wires/outlets. We have noticed a random "flicker" that happens throughout the day in the house. It is not tied to major appliances such as the air conditioner...
  4. k-n

    Sprinkler manifolds vs manifolds at each zone?

    I've owned 3 houses with "professionally" installed sprinkler systems and each one was quite different. I'm curious as to what is considered "best practice" for proper install given each sprinkler products company seems to tout different ways... I'm going to do this one myself and will only be...
  5. k-n

    Reworking my well - options on sprinkler side

    I am going to completely redo my well system. Currently I have a 3HP electric that can pull quite a bit of water out of the ground. I have a 1500 gallon storage tank. I have a goulds J10 1HP electric pump. I also have a higher end whole house pre, carbon, and post filtration system with a...
  6. k-n

    Plumbing in another toilet along a fairly long 3" septic run

    I'm going to have to cut into about 50' run of 3" pvc that is the main septic line in the crawl space under my home. It is plumbed in at both ends so I can't move it horizontally to get fittings into place. My plan is to cut into the existing line as cleanly as I can with a handsaw, clean up...
  7. k-n

    Looking for a high flow wall tub filler

    I've done quite a bit of searching. Either my goofle-fu isn't working or I'm not sure what I'm looking for. I'm not new to plumbing, cartridges, valves, etc., but I have never put in a high-flow wall application. Basically I'm looking for a high flow single handle or side by side two handle...
  8. k-n

    New Moen Shower Cartridge - Trickle of water

    New cabin, new plumbing. It's all pex 3/4 inch until it reaches a T to the fixtures. I have very good water pressure and have tested the water flow before/after shower cartridge. I am currently only allowing water pressure on the cold side and the hot side is still blocked until the floor...
  9. k-n

    Expansion tank mounting (electric)

    I'm about to plumb in the hot water heater and checked with my coop. They have backflow at the meter so I'm closed loop. Therefore I'm going to put in an expansion tank. It's a small 18" diameter electric 30 gallon in a TIGHT space so I don't have a lot of room to play. I have seen the...
  10. k-n

    Small bathroom plumbing using air admittance device

    I have a 600 sq foot cabin in progress and it's time for the bathroom. I have it roughed in 60" wide and 8' long. I plan to place a 30" sterling ensemble direct to stud shower/tub, 10" rough-round toilet, and a 24" shallow vanity. This will be the only bathroom. For the wall that will house...
Top
Hey, wait a minute.

This is awkward, but...

It looks like you're using an ad blocker. We get it, but (1) terrylove.com can't live without ads, and (2) ad blockers can cause issues with videos and comments. If you'd like to support the site, please allow ads.

If any particular ad is your REASON for blocking ads, please let us know. We might be able to do something about it. Thanks.
I've Disabled AdBlock    No Thanks