Search results

Based on attached picture: attached to the 3/4" copper pipe is a "1987" technology "thingy" and you can see the braided line that is going up to the refrigerator. We are remodeling kitchen, so fridge is out right now, but no matter how hard I tighten this thing, there is a small flow of water...

Hello, Ohio. I need to reroute plumbing (tearing down non-load bearing wall of course it had plumbing in it lol). From the attached picture can the PEX be this close to the electrical outlet? If no, would it be yes if I changed the outlet to GFI? NOTE* this section of the wall will then...

Hello, I have already cut (made shorter) the bath drain kit as much as I could... photos: Plumb 31: overview of p-trap and part of the drain Plumb 32: P-trap Plumb 33: part of P-trap that is currently a street When I put on the bath drain kit and sit the bathtub on it, since the p-trap is too...

Hello, First off, regardless who reads this question; I have asked previous questions: you guys are great! I made the mistake of not remembering how the old p-trap was connected therefore... photos: Plumb 17: old P-trap & drain kit part that connects Plumb 18: old P-trap and "build up gunk or...

Hello, The new bathtub drain is not in same spot as bathtub taken out, therefore...I need to either move the p-trap over 2.5 inches (14.5 inches from wall, instead of current 17") OR figure out how to adjust PVC bath drain rough in kit to make tub align with p-trap OR something else ?. I hope...

Hello, The previous tub/shower combo that I ripped out allowed for the air vent to be above subfloor (as seen by pics). Of course :), the new tub Delta Classic 400 won't allow this. Any suggestions on what to do with this vent. This alcove is on 2nd floor of 2 story residential, Ohio. Thank you.