Recent content by TCP

I think the previous owners had a small drip and tried tightening the bolts until it cracked. Not even sure how to find this piece now.

Hey guys and gals. My mother in law bought a place and I just noticed her toilet had a small leak when flushed. I have changed a few toilets in my life but have never seen or changed one of these.... The brand is Caroma and I don't even know what this piece is called or what's involved. Is...

Yes I saw your old post about this and I'm going back to the hardware store tomorrow to pick up some of the seam seal. I did put two very thin shims in the front and made sure the bowl did not rock before snuging down the two bolts in the back. Can the seam seal be used on my vanity top that...

Yes I plan to silicone around it once I got the ok from you guys! Having the bolts on the back pulling up on a plastic piece doesn't give it much stability.... Also wanted to use it for a few days in case there were leaks. The flange I had existing was like a two piece that had a rubber ring...

This may be a clearer photo.

Hello I just installed a TOTO Legato toilet which has that plastic unifit adapter with the rubber diaphragm. My question is when I set the toilet it seems to have only pushed down on the ring and I'm not sure if it's set correctly. I did hear and feel a small pop like it set but when I look...

So I ordered the new part but while I was waiting for it to arrive I decided to try and use the fast fill button a few times in hope of clearing anything that might have hung it up. It seems to have fixed it but if not I'll have extra part. Thanks to everyone who chimed in!

It's a taco 3350-t3 I believe.

So if everything is on pressure stays at 12. Been watching it for a while now. I know my system isn't piped correctly. But has been running for two years. Circulators are on supply side along with fill/prv and tank. Return line has nothing and can't get any one knowledgeable locally.

So I have hot water heat. I was doing some pre season checks. System coldand off is at 12psi as set by the automatic fill. I have an isolation valve on my expansion tank with a drain so I can test bladder pressure. So here is where it gets strange for me. The system is cold and not running...

Thank you for your replies so far. I'm a little confused, isn't the line that has 24 volts the C wire?

Just looking for heating, maybe something digital that can be programmed.

Looking to replace this old thermostat. One line has what appears to be 24 volts. Is this a low voltage direct replacement?

Sweet thanks Dave. I did think this was the more logical route. Just couldn't find any diy videos on flat bottom sink. We are going wall mounted for the faucet. Also floating vanity.... The wife has made this project as difficult as possible for me... Lol

So I'm looking to install a flat bottom vessel sink. I still need to have the countertop made and wasn't sure what size hole to have them drill. Laying the vessel on a flat surface I can see about 3/8 gap from the counter to the bottom of the drain hole. Do I install the pop up drain and...