Thanks! I pulled the handle before and the dome didn't come out. It looked like the width of the dome was wider than the top of the valve body. That's why I thought that maybe the valve body needed to come off. Possible the dome is just stuck and needs a little help. I'll try. Thank you!
Hi. I have a Brizo 64900 kitchen faucet that is leaking. Delta sent me a repair kit that contains new seats & springs. All the videos I've found show removing a dome cap to access all the parts that need replaced. This faucet has one big valve body cap. Anyone know if the entire valve body cap...
Hi everyone. I have a Triangle Tube Solo 110. It is about 5 years old. When it starts up, I hear a horn-like noise for about 15 seconds, then it stops when it ignites. I pulled the PVC off and the noise pitch changes and if I put a few fingers over the venturi, it muffles the noise. The fan...
Thanks for the response. I say "before" because I don't recall this problem happening the first year or two after the TT was installed. But, I also started seeing this after adjusting the CH Target Temp to lower over the summer. I put it back up to the default 186* and I haven't seen the...
Hi - I have a TT Prestige Solo 110 with the TT Phase 3 Indirect Fired Water Heater. I live in Granby, Colorado at around 8600 feet altitude. The night temps get down to around 0*.
I've been trying to figure out why we aren't getting the same heat as before (a little chilly in the morning)...