I am remodeling the bathroom and just completed the demo. The toilet flange was sitting on the tile that I took out. The new tile is too high and cant fit under the flange. But the flange is now higher than the plywood and cant push down so I need to put something only in-between the flange and...
I was able to get it working again by tapping on the pressure switch. There was no reset button on it so I tapped on it. First tap started to move things and second one seemed to get things back to normal. Wondering what might have happened and if it was ok to tap on the pressure switch.
Just an update on the last response. I ordered the falcon with the quick clack connect and it didn't fit. I also got the falcon fip to fip so I'm just using that. So far it's a much better seal then what I had before. No drip.
It takes me a few times reading the responses to figure out what is being said. I see now he was saying it would had been better to have the system properly sized.
I did get the brine recovery fixed. I had the wrong instructions.
The corrugated flex line I'm using has a small drip. I got a...
Well that sucks that I wasted money on this but I appreciate you guys telling me the truth. Since it's connected should I just leave it on and not use the brine recovery settings? I connected the drain line to it and everything seems fine. Just wondering if I should take this off or not. I...
Darn. I'm kind of bummed that I got this BRV now. At this point it's just something connected to my control valve that is sending water through another valve to drain and I'm thinking I don't even bother to set it up to recover the brine if you are that skeptical of it even working. The one I...
I have taken water from where the tank is and it was clear. I also have a spindown filter for my sprinkler system and after a couple of months the screen still looks clean.
I'll take that as a good sign. Thank you.